One-Touch Repeater Function; Transmit Frequency Monitor Check; 1750 Hz Tone Burst - Icom IC-9100 Instruction Manual

D
This function allows you to set the repeater operation
by holding down one switch.
First, set the frequency offset as well as the repeater
access tone frequency (p. 163).
q Select the desired frequency band. (p. 35)
w In the FM mode, push [A/B] to select VFO A.
e Rotate [MAIN DIAL] to set the desired receive fre-
quency (repeater output frequency).
r Push [MENU] to display the "M1" screen (Menu 1).
t Hold down [DUP](F-2) for 1 second to turn ON the

One-touch repeater function.

the function display.
OFF, if it is ON.
y Push [DUP](F-2) once or twice to switch the offset
direction.
u Communicate in the normal way.
D
transmitted signal without having to go through a re-
peater. This function helps you to check whether the
direct communication can be done, or not.
While receiving, hold down [XFC] to see if you can
directly receive the other party's transmitted signal.
quency offset are displayed on the function display.
D
A 1750 Hz tone is required to access most European
repeaters.
To transmit a 1750 Hz European repeater tone, hold
down [TON](F-4) during repeater operation. (p. 65)
This function is not available for non-Euro-
pean versions.
M1
A G C D U P
Hold down
1 4 5 . 9 2 0 0 0
M1
A G C D U P
Transmit (repeater receive)
frequency appears
-
M1
A G C D U P
M1
A G C D U P
Frequency Offset direction and value.
M1 1 4 5 . 9 2 0 0 0
A G C D U P
RECEIVE AND TRANSMIT
A F C T O N S C P
Appears Appears
A F C T O N S C P
[XFC]
1 4 5 . 9 2 0 0 0
A F C T O N S C P
Hold down
– 6 0 0 . 0 k
A F C T O N S C P
Blinks
A F C T O N S C P
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
66