System Q; Audio Control - Kenwood KDC-5023 Instruction Manual

System Q

You can recall the best sound setting preset for different types of
music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [System Q] button.
Each time the button is pressed the sound setting switches.
Sound setting
Flat
User memory
Rock
Pops
Easy
Top 40
Jazz
• User memory: The values set on the <Audio control> (page 9).
• Each setting value is changed with the <Speaker setting> (page
10).
First, select the speaker type with the Speaker setting.

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
Display
"Flat"/ "FLAT"
"User"/ "USER"
"Rock"/ "ROCK"
"Pops"/ "POPS"
"Easy"/ "EASY"
"Top40"/ "TOP40"
"Jazz"/ "JAZZ"
— 9 —
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display
Bass level "Bass"/ "BAS"
Middle level "Middle"/ "MID"
Treble level "Treble"/ "TRE"
Balance "Balance"/ "BAL"
Fader "Fader"/ "FAD"
Non-Fading level* "NF Level"
Front/Rear High Pass "HPF"
Filter*
Non-Fading "LPF NF"
Low Pass Filter*
Volume offset "V-Offset"/ "V-OFF" –8 — ±0
Loudness "LOUD"
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
• Loudness: Compensating for low and high tones during low
volume.
• * Function of the KDC-MPV7023/6023
5
Exit Audio Control mode
Press the [AUD] button.
Range
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–15 — +15
Through/100/125/170
Hz
50/80/120/Through Hz
ON/OFF