Contrast Adjustment; Switching Preout - Kenwood KDC-5023 Instruction Manual

Quick call up the preset color
Press the desired [1] — [4] button.
Button
[1]
[2]
[3]
[4]
Selecting the Color mode
Press the [6] button.
Each time the button is pressed the Color mode switches as
shown below.
Display Color mode
"Scan" The color changes in sequence.
"SRC" The color changes according to the selected source.
"Time" The color changes every 6 hours.
Keeps the presently set color.
Blue fine adjustment
1 Press the [3] button for at least 2 seconds.
2 Press the [4] or [¢] button.
When the blue fine adjustment is completed, press the [3]
button.

Contrast Adjustment

Adjusting the display contrast.
Display and Setting
"Contrast 0"/ "CONT 0"
"Contrast 5"/ "CONT 5" (Original setting)
"Contrast 10"/ "CONT 7"
Color
Silky White
Red
Blue
Blue Green
— 27 —
Function of the KDC-MPV7023/KDC-6023
Dimmer
Dimming this unit's display automatically when the vehicle light
switch is turned ON.
Display
"Dimmer ON"
"Dimmer OFF"
Function of the KDC-MPV7023/KDC-6023

Switching preout

Switching the preout between the rear and non-fading. (In non-
fading it outputs without effect from the fader control.)
Display
"SWPRE Rear"
"SWPRE N-Fad"
Function of the KDC-MPV7023/KDC-6023
Dual Zone System <In External disc, or Auxiliary
input source>
Makes the sound different for the front channel and rear
channel.
Display Setting
"Zone 2 OFF" The front and rear are the same source sound.
"Zone 2 ON" The front and rear are the different source sound.
• When the Dual Zone System is on, there is only sound effect
including Audio control for internal source.
• When you set the Dual zone system to ON while the non-fading
preout is switched ON, the sound of the non-fading preout isn't
output.
• When the source is selected to VZ-7000P/N (optional accessory),
the VZ-7000P/N sound is not output if the Dual Zone System is
turned ON.
Setting
The display dims.
The display doesn't dim.
<In Standby mode>
Setting
Rear preout.
Non-fading preout.