System Control Cord; (Dpf-3010/Dpf-2010 Only); System Connections - Kenwood DPF-1010 Instruction Manual

System connections

Caution:
6
Do not plug in the power lead until all connections are com-
pleted.
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Rear panel: 10 cm
DIGITAL OUTPUT jack

(DPF-3010/DPF-2010 only)

SL 16/XS8 switch
OUTPUT DIGITAL SYSTEM CONTROL
OUTPUT
OPTICAL
L
SL 16 XS-8
R
Remove the
protection cap
when using the
DIGITAL OUTPUT
(OPTICAL) jack.
Audio cord
Commercially-available
optical fiber cable
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
8
ƒ
SYSTEM
CONTROL

System control cord

CD
L
R
Amplifier
DIGITAL
INPUT
OPTICAL
MD recorder
DPF-3010/2010/1010 (En)
™
To AC outlet
To wall AC outlet
To AC outlet