System Control Cord; System Connections - Kenwood DP-4090 Instruction Manual

System connections

Caution:
4
Do not plug in the power lead until all connections are com-
pleted.
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm
(DP-5090 only)
LINE 1 and LINE 2 output are the same
pair of signals. Use these jacks to connect
the unit to other system components.
OUTPUT
LINE 1 LINE 2
L L
R R
(Except for DP-4090)
Remove the protection cap
when using the DIGITAL
OUTPUT (OPTICAL) jack.
Audio cord
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Rear panel: 10 cm
75 coaxial cable with RCA PIN.
(Commercially-available)
DIGITAL
OUTPUT
TEXT
OPTICAL COAXIAL
Commercially-available
optical fiber cable
CD
L
R
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
Commercially-available
optical fiber cable
(OPTICAL)
DIGITAL INPUT
(COAXIAL)
SYSTEM
CONTROL
ƒ
SL16 XS 8
SL 16/XS8
6
switch
DIGITAL
INPUT
OPTICAL
Digital component (MD, DAT, etc.)
2 3AC220-240V
AC110-220V

System control cord

SYSTEM
CONTROL
Digital amplifier
(or ordinary amplifier,
receiver, etc.)
To wall AC outlet
DP-5090/4090 (En)
¡
To AC outlet