Mask Key; Touch Sensor Tone - Kenwood KRC-PS979R Instruction Manual

Mask Key

If you have transmitted the Mask Key's signal once to the unit
in advance, you will have to transmit it once again if the unit
has been removed from the battery. This function helps
prevent theft.
When using the unit for the first time:
In order to deactivate the demonstration mode, be sure to
press the transmit button to transmit the Mask Key's signal.
If this procedure is not carried out, the control panel of the unit
will re-open in two seconds even with your vehicle's ignition
turned off.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
2
Hold down the MENU button for one second or more.
"MENU" is displayed and "Mask key" appears in the display.
Hold down either the 4 or ¢ button for one second or
3
more.
"BAR BAR 1" will appear in the display, indicating the
setting mode has been entered.
4
Press the transmit button on the Mask key until "BAR BAR
BAR" is displayed.
"BAR BAR 2" will be displayed.
Transmission part
Transmit button
NOTE
• Keep the Mask Key close to the signal sensor when you
transmit the Mask Key's signal.
• If the Mask Key's signal does not be received correctly, the
display will return to "BAR BAR 1". In this case, repeat the
— 35 —
procedure in step 4.
5
Press the transmit button on the Mask key until "BAR BAR
BAR" is displayed.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "BAR BAR
appear in the display, indicating the setting mode has been
entered. Repeat steps 4 and 5 above, and transmit the signal.
You can start operating the unit again when "BAR BAR BAR"
appears in the display.

Touch Sensor Tone

This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"Beep ON" : Beep setting is on. (Default setting)
"Beep OFF" : Beep setting is off.
NOTE
The beep sound is not output from the preout jacks.
1" will