Setup Menu Screen; Code Security Screen; Mask Key; Exit The Code Security Screen - Kenwood KVT-M700 Instruction Manual

7-inch wide screen monitor-receiver
Hide thumbs Also See for KVT-M700:
Table of Contents

Advertisement

Setup Function

Code Security Screen

T h e
s y s
t
e m
w
a
i
t
i
n
g
M
A
S
K
K
E Y
P
l
e
a
s
e
i n p u t
S E C U R I T Y

Mask Key

Because authorization by the Mask Key is required
when it's removed from the vehicle, personalizing this
unit by using the Mask Key is a help in preventing
theft.
1
Enter the Mask Key's signal
Hold down the transmit button on the Mask key until
the full transmit level indicator lights up in the
display."Checking." is displayed.
Transmission part
Transmit button
Keep the Mask Key close to the signal sensor when you
transmit the Mask Key's signal.
2
Reenter the Mask Key's signal
Hold down the transmit button on the Mask Key until
the full transmit level indicator lights up in the display.
Return to the setup menu screen.
Press the Reset button and when it's removed from
the battery power source
1 Turn the power ON
The vehicle engine turns ON.
"The system is now waiting for your MASK KEY
signal. Please input now." is displayed.
2
Enter the Mask Key's signal
Repeat steps 4 and 5 abobe, and enter the Mask
Key's signal.
The "ALL OFF" screen is displayed.
The unit can be used.

Exit the Code Security Screen

Touch the [RTN] button.
Return to the setup menu screen.
10
i s
n o w
f o r
y o u r
s i g n a l .
n o w .
RTN

Touch Panel Adjustment Screen

T O U C H
P A N E L
P l e a s e
T o u c h
t h e
C e
n
t e r
t h e
B u
t
t o n
R i g h t - T o p
C A N C E L

Adjusting the Touch Position

The touch panel can be adjusted if the position
touched and the operation performed do not match.
1
Accurately touch the mark at the upper right.
2
Accurately touch the mark at the lower left.
When the mark at the lower left is touched, the
adjustment is completed and the system setup menu
screen reappears.
• If the [CANCEL] button is touched without touching the
button at the upper right, the adjustment is canceled and the
screen that was set before switching to the system setup
menu reappears.
• If the [CANCEL] button is touched after touching the button
at the upper right, the button at the upper right reappears.
• If the [RESET] button is touched, the settings are reset to the
factory defaults and the setup menu screen reappears.
A D J U S T
o f
i n
t h e
C o r n e r .
R E S E T

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents