Connecting Wires To Terminals - Kenwood KDC-3028 Instruction Manual

Connecting Wires to Terminals (KDC-MP4028/KDC-MP428)
Front left output (White)
Front right output (Red)
Rear left output (White)/Sub Woofer left
output (White) (KDC-MP428 only)
Rear right output (Red)/Sub Woofer right
output (Red) (KDC-MP428 only)
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the KENWOOD navigation
system, consult your navigation manual.
To car light control switch
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
28
|
English
To KENWOOD disc changer/ External optional accessory
To front left speaker
To rear left speaker
To rear right speaker
Car fuse box
–
FM/AM antenna input
To connect these leads, refer to
the relevant instruction manuals.
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUM
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
ACC
Ground wire (Black) - (To car chassis)
AUX left input (White) (KDC-MP428 only)
AUX right input (Red) (KDC-MP428 only)
Sub Woofer left output (White)
(KDC-MP4028 only)
Sub Woofer right output (Red)
(KDC-MP4028 only)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)