Changing The Remote Access Default Logon Name And Password; Section 6 Using The Os/2 Host Process Switcher - NEC Xen IPK Installation Manual

Xen IPK Xen Mail CTI Installation Guide
S 7
E C T I O N
C
HANGING THE
REMOTE ACCESS
DEFAULT LOGON NAME
AND PASSWORD
Remote Access
Each phone book entry you create uses a logon name and password to
access the voice messaging system. The default logon name is "support,"
and the default password is "voice." For improved security, you may want to
change these settings.
The logon name and password are case-sensitive and must be set the
same on both the voice messaging system and the support computer's
phone book entries. On the voice messaging system, there is a separate file
for direct and modem connection settings. To change these settings,
perform the following procedure.
To change the remote access default logon name and password
1 Establish a remote access connection with the voice messaging system.
2 Use the OS/2 Process Switcher window to open an OS/2 command
prompt as described in "Using the OS/2 host process switcher" on page
15.
3 At an OS/2 command prompt, type
4 Type and press ENTER.
cd \cs2
5 Type and press ENTER.
cs2gen
6 From the OS/2 Script File Generator menu, press F1 to load the script
files.
7 Type the number corresponding to the script file you want to load:
• If you are using a direct connection, select Direct.cs2 and press ENTER.
• If you are using a modem connection, select Modem.cs2 and press ENTER.
8 Press F7 and follow the on-screen instructions to change the logon
name on the voice messaging system.
The current settings are shown at the bottom of the screen.
and press ENTER.
c:
Chapter 3 - 35