Maintenance; Confirmation Procedure Of Local Terminal Operation Using Self-Loop - Sony PCS-1 System Integration Manual

2-1. Confirmation Procedure of Local
Terminal Operation Using Self-Loop
A self-loop is the reflected loop in the codec of the main
unit.
Operation procedure
1. The launcher menu below is displayed when the power
switch of a communication terminal is turned on.
Connect
Phone Book
Dial
Menu
Show Help
2. Select a dial using the ↑, ↓, ←, and → buttons of a
remote controller and press the ENTER button or the
CONNECT/DISCONNECT ( / ) button of a remote
controller.
The dial menu is displayed.
Dial
IP
A2
B1
B2
C1
C2
More Options
3. Select the line type.
Select "Line Type" using the ↑, ↓, ←, and → buttons
of a remote controller and press the ENTER button.
Then, select "LAN" or "ISDN" using ↑ and ↓ buttons
and press the ENTER button.
PCS-1/1P
Section 2

Maintenance

Angle Adj.
Line I/F
LAN
LAN Bandwidth
1024 Kbps
Dial Save
4. Select the number of lines used.
Select "LAN Bandwidth" or "Number of Lines" using
the ↑, ↓, ←, and → buttons of a remote controller and
press the ENTER button.
Then, select "1920 kbps" or "12B" using the ↑ and ↓
buttons and press the ENTER button.
5. Select column IP or A using the ↑, ↓, ←, and →
buttons of a remote controller and press the ENTER
button.
Enter * in column A from a remote controller two
times.
Dial
A
More Options
6. Select "Dial" using the ↑, ↓, ←, and → buttons of a
remote controller and press the ENTER button or the
CONNECT/DISCONNECT ( / ) button of a remote
controller.
A self-loopback is started and "Dialing" is displayed
on the monitor screen. "Meeting starts!" is displayed
when the loopback is completed. In this case, confirm
that an image and voice are looped.
Line I/F
ISDN
Number of Lines
6 B
Dial Save
2-1