Foundry® Fastiron® Edge 2402; Hp Procurve® 420Ap - HP 800 User Manual

100 supp-resp-timeout 30
configure netlogin dot1x eapol-transmit-version v1
configure netlogin dot1x guest-vlan Guest
enable netlogin logout-privilege
enable netlogin session-refresh 3
configure netlogin base-url "network-access.com"
configure netlogin redirect-page "http://
www.extremenetworks.com"
configure netlogin banner ""
Foundry® FastIron® Edge 2402
dot1x-enable
auth-fail-action restricted-vlan
auth-fail-vlanid 5
mac-session-aging no-aging permitted-mac-only
enable ethe 1 to 4
aaa authentication dot1x default radius
radius-server host 10.11.100.10 auth-port 1812 acct-port 1813
default key 1 $6\-ndUnoS!--+sU@
interface ethernet 1
dot1x port-control auto
sflow-forwarding
!
interface ethernet 2
dot1x port-control auto
sflow-forwarding
!
interface ethernet 3
dot1x port-control auto
sflow-forwarding
!
interface ethernet 4
dot1x port-control auto
sflow-forwarding
!
HP ProCurve® 420AP
This section shows how to configure the security settings on the 420AP so that
user access may be controlled using Dynamic VLAN provision-
ing.
HP ProCurve Access Point 420#configure
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#no ip dhcp
HP ProCurve Access Point 420(if-ethernet)#ip address <IP of
Access Point Netmask Gateway>
HP ProCurve Access Point 420(if-ethernet)#end
HP ProCurve Access Point 420(config)#management-vlan 200
tagged
HP ProCurve Access Point 420(config)#interface wireless g
802.1X Quarantine Method
Setting Up the 802.1X Components
11-51