Secondary Method - Traction And Auger Housings Separated: Toro Models 38065 And 38080 - Toro Lawn-BoySeries Service Manual

Auger Gearbox Service
9. The auger flighting is attached to the auger shaft
with one bolt and locknut. Reach through the
holes in the drum augers to access. On models
without drum augers, the bolts are easily
accessible (Figure 11).
Figure 11
1. Access hole
The auger assembly can be separated from the
traction assembly. However, it is generally not
necessary to work on the auger. Should the auger
pulley be rusted on the shaft, it might be easier to
remove the pulley with the traction assembly out of the
way.
Secondary Method — Traction and Auger
Housings Separated: Toro Models 38065
and 38080
1. Remove the belt cover. Loosen the belt guide and
remove the auger belt (Figure 12).
Figure 12
1 - 4
2. Drain the fuel and oil and stand the machine up on
its auger. Support or brace to prevent tipping
(Figure 13).
1
3. Disconnect the chute crank rod at the auger
MVC-533
(Figure 14).
4. Remove the lower cover from the traction
assembly.
2768-021
Two Stage Snowthrower Drive Systems Manual
Figure 13
Figure 14
2768-027
MVC-534