Led Indicators And Projector Condition - Sanyo PLV-80 Service Manual

Chassis Description

LED indicators and projector condition

Check the Indicators for projector condition.
Indicators
LAMP
WARNING
READY
REPLACE TEMP.
green
yellow red
● ●
●
✽
✽
●
✽
❂
✽
❂
✽
●
❂ ❂
✽
●
✽
❂
✽
❂
❂ ●
❂ ●
✽
❍
❍ ❂
• • • on • • • flashing
When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow,
✽
replace the projection lamp with a new one promptly. Reset the Lamp Replace Counter after replacement of the lamp.
LAMP
red
● ●
The projector is OFF. (The AC Power Cord is unplugged.)
❍ ❍ The projector is READY to be turned on with the POWER ON-OFF button.
❍ ● The projector is operating normally.
The Warning Temp. Indicator flashes red to let you know the internal
temperature of the projector exceeds the normal level. If the temperature goes
up further, the projector will be turned off automatically and the Ready indicator
● ❍ will go out. When the projector is cooled down enough and the temperature
returns to normal, the READY indicator lights green and the projector can be
turned on. (The WARNING TEMP. indicator keeps flashing.) Check and clean
the Air Filter.
The projector is cooled down enough and the temperature returns to normal.
❍ ❍ When turning on the projector, the WARNING TEMP. indicator stops flashing.
Check and clean the Air Filter.
The projector is being cooled down. It cannot be turned on until the READY
● ❍
indicator lights green.
The projector detects an abnormal condition and cannot be turned on. Unplug
the AC Power Cord and plug it again to turn on the projector. If the projector is
❂ ❍
turned off again, disconnect the AC Power Cord and contact the dealer or the
service center for service and checkup. Do not leave the projector on. It may
cause electric shock or a fire hazard.
❂ ● The projector is in the Power management mode.
❍ ● The temperature inside the projector is abnormally high.
The temperature inside the projector is abnormally high. The projector cannot
be turned on. When the projector is cooled down enough and the temperature
● ❍
returns to normal, the READY indicator lights green and the projector can be
turned on.
The lamp cannot light up. (The projector is preparing for stand-by or the
● ❍ projection lamp is being cooled down. The projector cannot be turned on until
cooling is completed.)
The lamp cannot light up. (The lamp has been cooled down enough and the
❍ ❍
projector is in stand-by mode and ready to be turned on with the POWER
ON-OFF button.)
The life of the projection lamp draws to an end.
● ●
Replace the lamp and then reset the Lamp time. The indicator will turn off.
●
• • • dim
Projector
●
• • • off
-54-