Mitsubishi 3000GT Service Manual page 355
Chassis and body
Hide thumbs
Also See for 3000GT:
- Service manual (739 pages) ,
- Workshop manual supplement (58 pages) ,
- Workshop manual supplement (56 pages)
Table of Contents
Advertisement
HARNESS INSPECTION
A B Harness side
connector
SENSOR INSPECTION
Refer to P.l3A-143.
INSTALLATION
Refer to P.l3A-143.
MULTIPORT
On-Vehicle Inspection of MFI
FUEL INJECTION - Components
Measure the power supply volt-
age of the heated oxygen sensor.
Connector: Disconnected
l
l
Ignition switch: ON
Battery voltage
Check for an open-circuit, or a
short-circuit to ground, between
the enginecontrol module and the
heated oxygen sensor.
l
Heated oxygen sensor con-
nector: Disconnected
Engine control module con-
l
nector: Disconnected
Check for continuity of the ground
circuit.
Connector: Disconnected
l
TSB Revision
Repair the
harness.
( A l , Bl -
3
Repair the
harness.
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 3000GT and is the answer not in the manual?
Questions and answers
need torque specs for a head gasket job on my 1995 - vr-4
For a 1995 Mitsubishi 3000GT VR-4 using ARP head studs, torque the head studs in three steps: first to 30 ft/lbs, then 60 ft/lbs, and finally 90 ft/lbs. After reaching 90 ft/lbs, back each stud out about 1/6 turn and re-tighten to 90 ft/lbs again, following the correct sequence. This ensures even clamping and proper head seating.
This answer is automatically generated