Mitsubishi 3000GT Service Manual page 332
Chassis and body
Hide thumbs
Also See for 3000GT:
- Service manual (739 pages) ,
- Workshop manual supplement (58 pages) ,
- Workshop manual supplement (56 pages)
Table of Contents
Advertisement
Function
Item No.
Data reading 22
NOTE
5v
Normal waveform
HARNESS INSPECTION
MULTIPORT
FUEL INJECTION
Components
Data display
Check condition
Idle speed
Engine: Running at idle At -20°C (4°F)
l
Closed throttle position
l
switch: ON
(1) Run the engine at idle speed.
(2) Connect the probe to the oscilloscope pick-up point as
shown in the circuit diagram, and check the waveform.
Connector: Disconnected
l
Ignition switch: ON
Connector. Disconnected
l
TSB Revision
Coolant temperature
Standard value
1,300-l ,500 rpm*2
At 0°C (32°F)
1,300-l ,500 rpm*2
At 2O"C(68"F)
1,300-l ,500 rpm*2
At 4O"C(104"F)
1,050-l ,250 rpm*2
At 8O"C(176"F)
600-800 rpm
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 3000GT and is the answer not in the manual?
Questions and answers
need torque specs for a head gasket job on my 1995 - vr-4
For a 1995 Mitsubishi 3000GT VR-4 using ARP head studs, torque the head studs in three steps: first to 30 ft/lbs, then 60 ft/lbs, and finally 90 ft/lbs. After reaching 90 ft/lbs, back each stud out about 1/6 turn and re-tighten to 90 ft/lbs again, following the correct sequence. This ensures even clamping and proper head seating.
This answer is automatically generated