Cable Box And/Or Dbs Receiver Control Setting (Hdd & Dvd Deck Only) - JVC DR-MX1S Instructions Manual

INITIAL SETTINGS
24
EN
Cable Box and/or DBS Receiver Control
Setting (HDD & DVD Deck only)
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box and/or DBS receiver's channels during timer recording.
NOTES:
The Controller is effective for "VCR Plus+ C
( pg. 55), or "Manual Timer Programming" (
When connecting your cable box, refer to its instruction manual.
Installing Controller
1
If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2
Fix securely using the adhesive strip attached on the back of the
Controller.
Your unit
3
Connect the controller to the unit.
a
Cable box or DBS receiver
Controller
3 ® Timer Programming"
pg. 57).
Cable box or DBS
receiver
Controller
(suggested locations)
To RF output To Audio/video
output
Transmitter
or
To [VHF/UHF IN] To [AUDIO/
(HDD/DVD)
VIDEO INPUT]
Your unit
CABLE
BOX
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver to the
[VHF/UHF IN] (HDD/DVD) connector on the rear of your unit.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the [AUDIO/VIDEO INPUT] connectors on the rear
of the unit.
If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit's [AUDIO/VIDEO
INPUT] connectors and the cable box to your unit's [VHF/UHF IN]
(HDD/DVD) connector.
4
Connect the Controller to the [CABLE BOX] connector on the
rear panel.
Setting Brand And Channel
After installation, set the cable box and/or DBS receiver's brand and
channels correctly; otherwise, the Controller cannot work correctly.
Turn on the unit.
Turn on the TV and select the video channel (or AV mode).
Slide the TV/CABLE/DBS/DVD switch to DVD.
HDD
ENTER
1
Turn on the cable box and/or DBS receiver.
2
Press HDD or DVD so that the HDD or DVD lamp lights up on
the unit.
3
Press SET UP to access the Main Menu screen.
4
Press w e to select "INITIAL SET UP", then press t.
5
Press w e to select "STB SET", then press t.
6
Press rt to select "CABLE
SET UP" or "DBS SET UP", then
press ENTER.
7
Press rt to select "CABLE
BOX OUTPUT CHANNEL" or "DBS
RECEIVER OUTPUT CHANNEL",
then press ENTER.
CABLE/DBS
TV DVD
DVD
rtwe
SET UP
DVD VIDEO SET UP HDD/DVD SET UP FUNCTION SET UP INITIAL SET UP
TUNER SET STB SET CLOCK SET
CABLE SET UP DBS SET UP
SET UP ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > CABLE SET UP
CABLE BOX OUTPUT CHANNEL OFF
BRAND 1
RETURN
SET UP ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT SELECT