Cable Box And/Or Dbs Receiver Control Setting (Dvd Deck Only) - JVC DR-MV1 Instructions Manual

INITIAL SETTINGS
22
EN
Cable Box and/or DBS Receiver Control
Setting (DVD Deck Only)
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box or DBS receiver's channel during timer recording.
NOTES:
The Controller is not supplied with this unit. It can be requested by
mailing in the completed JVC Cable Mouse Certificate that is
included with the accessory package.
The Controller is effective for "VCR Plus+
( pg. 41), "Manual Timer Programing" (
Timer Programing" ( pg. 43).
When connecting your cable box, refer to its instruction manual.
Installing Controller
1
If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2
Fix securely using the adhesive strip attached on the back of the
Controller.
Your unit
3
Connect the controller to the unit.
a
Cable box or DBS receiver
Controller
® Timer Programing"
pg. 42), or "On-Disc
Cable box or DBS receiver
Controller
(suggested locations)
To RF output To Audio/video
output
Transmitter
or
To VHF/UHF IN To AUDIO/
(DVD) VIDEO INPUT
Your unit
CABLE
BOX
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver
to the VHF/UHF IN (DVD) connector on the rear of your unit via
antenna splitter.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear
of the unit.
If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit's AUDIO/VIDEO
INPUT connectors and the cable box to your unit's VHF/UHF IN
(DVD) connector via antenna splitter.
4
Connect the Controller to the CABLE BOX connector on the rear
panel.
VCR/DVD
ENTER
SET UP
Setting Brand And Channel
After installation, set the cable box or DBS receiver's brand and
channel correctly; otherwise, the Controller cannot work correctly.
Turn on the unit.
Turn on the TV and select the video channel (or AV mode).
Slide the TV/CABLE/DBS/DVD switch to DVD.
1
Turn on the cable box or DBS receiver.
2
Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
3
Press SET UP to access the Main Menu screen.
4
Press w e to select "INITIAL SET UP", then press ENTER.
5
Press w e to select "STB SET", then press ENTER.
6
Press rt to select "CABLE
BOX SET" or "DBS RECEIVER
SET", then press ENTER.
7
Press rt to select "CABLE
BOX OUTPUT CH" or "DBS
RECEIVER OUTPUT CH", then
press ENTER.
1 2 3
4 5 6
7 8 9
0
rtw e