Maintenance - Star Trac eSPINNER Installation And Operation Manual

Maintenance

This section provides the procedures to maintain the Spinner
models are noted where applicable.
Moving and Leveling
To move the bike to a new location: Lift the bike from the rear and use the front wheels (located on the front leg, below the han-
dlebar) to roll the bike from one location to another.
To level the bike: Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven
floor surfaces.
Preventive Maintenance
Perform regular scheduled preventive maintenance procedures to maintain your Spinner
tion.
TOOLS
Tools required for service and maintenance of your Spinner
Tool
Pedal Wrench, 15mm*
Shimano-compatible Bottom Bracket Tool*
Cotterless Crank Puller*
Metric Allen Wrench Set and Metric Socket, 2mm ~ 6mm
Crescent (adjustable) Wrench
Torque Wrench
Available at local bike or fitness-related stores.
Daily Maintenance
The service life of your Spinner
cedures. Dry the Spinner
cleaner and water solution.
Wipe Down / Cleaning
To prevent the build-up of rust and other forms of corrosion, wipe down the bike at the end of each day (or preferably at the end of
each class). Raise all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration
can settle. Give particular attention to the following areas:
Handlebar
Back leg assembly
Pop-pins
NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the bike.
NOTE: Release all tension from the resistance knob after each use to allow for perspiration to evaporate. If bikes are used in a
class setting, the instructor may direct class participants to release all tension for the resistance knob after each use.
44
indoor cycling bike will be determined by how consistently you perform the daily maintenance pro-
®
indoor cycling bike after each use to remove sweat and moisture. It is best to use a liquid non-abrasive
®
Seat / adjustable slide for the seat
Chain guard
Leveling feet
indoor cycling bikes in serviceable condition. Differences between
®
indoor cycling bike are listed below.
®
Purpose
Remove and install pedals.
Remove, install and adjust the bottom bracket. (Spinner
Remove crank.
Install and adjust leg bolts, chain tensioner, brake pad and crank
bolts.
Adjust chain tension.
Adjust crank arm.
indoor cycling bike in serviceable condi-
®
Flywheel
Brake knob and bolt assembly
V)
®