Connecting A Device Compatible With The Trigger Function; Connecting The Power Cable - Yamaha AVENTAGE RX-A1040 Owner's Manual

1 2 3 4 5 6 7 8 9 10

Connecting a device compatible with the trigger function

The trigger function can control an external device in conjunction with operating the
unit (such as powering on/off and input selection). If you have a Yamaha subwoofer that
supports a system connection or a device with a trigger input jack, you can use the
trigger function by connecting the external device to one of the TRIGGER OUT jacks.
TRIGGER OUT
1–2 jacks
The unit (rear)
TRIGGER
OUT
1
2
12V 0.1AMAX. TOTAL
• You can configure the trigger function settings in "Trigger Output1" and "Trigger Output2" (p.124) in the
"Setup" menu.
System connection
input
Yamaha subwoofer that
supports a system connection
7

Connecting the power cable

Before connecting the power cable (General model only)
Set the switch position of VOLTAGE SELECTOR according to your local voltage.
Voltages are AC 110–120/220–240 V, 50/60 Hz.
• Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC
wall outlet. Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a
potential fire hazard.
The unit (rear)
After all the connections are complete, connect the supplied power cable to the unit
and then to an AC wall outlet.
The unit (rear)
PREPARATIONS ➤ Connecting the power cable
VOLTAGE SELECTOR
VOLTAGE SELECTOR
220V-
240V
110V-
120V
To an AC wall outlet
36
En