Basic Settings; Setting The Digital Input (Digital In) Terminals; Selecting The Analogue Or Digital Input Mode - JVC LVT0858-001A Instructions Manual

Basic Settings

STANDBY
STANDBY/ON
PHONES
SETTING
Setting the Digital Input
(DIGITAL IN) Terminals
When you use the digital input terminals, register what components
are connected to which terminals (DIGITAL IN 1/2) so that the
correct source name will appear when you select the digital source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"DGT (Digital)" (with the current setting)
appears on the display.
CONTROL
* "1DVD2STB" is the initial setting. If you have already
changed setting, another combination will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate digital terminal setting.
• Each time you press the button, the display changes to show
the following:
CONTROL
PR ΙΙ
ANALOG
L C R
LPCM DSP
SUBWFR LFE
DOLBY D AUTO SR
LS S RS
DTS INPUT ATT
(back to the beginning)
CONTROL
Display
5/∞/3/2
TV DIRECT
DVD STB
CONTROL
ANALOG
L C R
LPCM DSP
SUBWFR LFE
AUTO SR
DOLBY D
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD STB
Source selecting buttons
(DVD, STB, TV)
Remote
NOT
*
VOL
VOL
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
PL ΙΙ AUTO MUTING
SLEEP AUTO MODE TA HEWS INFO RDS TUNED ST
HP
MH
Z
KH
Z INPUT SURROUND
VOL
ANALOG/DIGITAL
INPUT ATT
VCR TV TAPE FM/AM
INPUT
ANALOG/DIGITAL
Note:
When shipped from the factory, the DIGITAL IN terminals have been
set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For STB (Set Top Box)

Selecting the Analogue or Digital Input Mode

When you have connected digital source components using both the
analogue connection and the digital connection methods (see page 7),
you need to select the input mode correctly.
1
Press one of the source selecting buttons (DVD,
STB, or TV)
*
input mode.
DVD
Note:
* Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See "Setting the Digital Input (DIGITAL IN)
Terminals".)
2
Press INPUT ANALOG/DIGITAL (INPUT
ATT)—or ANALOG/DIGITAL INPUT on the
remote control—to select the analogue or digital
input mode.
• Each time you press the button, the input mode alternates
between the analogue input ("ANALOGUE"*) and the digital
input ("DGTL AUTO").
INPUT
ANALOG/DIGITAL
INPUT ATT
* "ANALOGUE" is the initial setting.
TO BE CONTINUED TO THE NEXT PAGE
SURROUND
ON/OFF MODE
MASTER VOLUME
for which you want to change the
STB VCR TV
ANALOG L R
SUBWFR
DOLBY D DOLBY D
13