Connecting Audio/Video Components - JVC LVT0858-001A Instructions Manual

Connecting Audio/Video Components

Turn off all components before connections.
Audio cords and optical digital cords are not supplied with this unit. Use the cords supplied for the other components or
purchase them at an audio or electric appliance store.
Digital coaxial cord (supplied 1 cable)
A
B
Digital optical cord (not supplied)
Digital connections
DIGITAL IN
DIGITAL 1
DIGITAL 2
(STB)
Before connecting an
optical digital cord,
unplug the protective
plug.
RX-E111R/
RX-E112R
Analogue
connections
AUDIO
LEFT
RIGHT
OUT IN
(REC) (PLAY)
TAPE
(DVD)
C
Audio cord (not supplied)
C
SCART cable (supplied 1 cable)
D
A
COAXIAL
DIGITAL OUT
B
OPTICAL
DIGITAL OUT
Illustrations of the input/output terminals
are typical examples.
When you connect other components, refer
also to their manuals since the terminal
names actually printed on the rear vary
among the components.
• When shipped from the factory, the DIGITAL
IN terminals have been set for use with the
following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For STB (Set Top Box)
If you connect other components, change the
digital input (DIGITAL IN) terminal setting
correctly. See "Setting the Digital Input
(DIGITAL IN) Terminals" on page 13.
• Select the digital input mode correctly.
See "Selecting the Analogue or Digital Input
Mode" on page 13.
If you connect a sound-enhancing device such
as a graphic equalizer between the source
components and this unit, the sound output
through this unit may be distorted.
AUDIO
LEFT
RIGHT
OUT IN
TO BE CONTINUED TO THE NEXT PAGE
DVD Player
STANDBY
STANDBY ON
DOLBY
D I G I T A L
STB (Set Top Box)
Cassette Deck
7