Table of Contents
Advertisement
Auto Set Up
Auto Channel Set/Auto Clock Set/Auto Guide
Programme Number Set
After the A button on the unit (or DVD A on the remote
control) is pressed for the first time to turn on the unit, the Auto
Set Up function sets the tuner channels, clock and Guide
Programme numbers automatically.
A
ENTER
CABLE/SAT
TV
DVD
DVD A
Selection Keys
FGDE
Before starting, make sure of the following:
●
The TV aerial cable should be connected to the unit.
●
The unit's mains power cord should be connected to a mains
outlet.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Press A on the unit or DVD A on the remote control to turn
on the unit. The AUTO SET/T-V LINK display appears on the TV
screen.
2
Press selection keys to
select AAUTO SETB, then
press ENTER. The AUTO
SET screen will appear.
●
When AUTO SET is
completed, ASCAN
COMPLETEDB appears on
the TV screen. Select AOKB.
ATTENTION:
AAUTOB blinks on the front display panel; do NOT press any button
on the unit or remote control until the front display panel shows
A– –:– –B as illustrated on page 21.
●
When you have connected the unit to a TV offering T-V Link via a
fully-wired 21-pin SCART cable (A pg. 18) and the TV is turned
on, the unit automatically performs the Preset Download
(A pg. 20) even if you select AAUTO SETB for Auto Set Up
function.
ATTENTION:
Once you have performed Auto Set Up, even if the unit's memory
backup has expired, all the stored stations and their Guide
Programme numbers remain in the unit's memory and the unit
will not perform Auto Set Up again. The unit only performs Auto
Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
●
Tuner setting (A pg. 74)
●
Clock setting (A pg. 77)
If a new station starts broadcasting in your area, perform tuner
setting. (A pg. 74)
NOTES:
●
In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto Clock
Set nor Auto Guide Programme Number Set.
●
Auto Clock Set may not function properly depending on the
reception condition.
After AAuto Set UpB is completed, perform AMonitor SetB on
page 23.
INITIAL SETTINGS
19
EN
INITIAL SET UP > AUTO CH SET
AUTO SET
T-V LINK
SET UP
ENTER
SELECT WITH @ THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > AUTO SET
AUTO SET
PLEASE WAIT...
CANCEL
ENTER
SELECT WITH @ THEN PRESS [ENTER]
SET UP
PRESS [SET UP] TO EXIT
EXIT
SELECT
Advertisement
Table of Contents
