I.link Timer Programming - JVC HD-DH5US Instructions Manual

48
EN
i.LINK Timer
Programming
•
Turn on the VCR and the TV (and/or Digital Set Top
Box).
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
D A
VCR
CABLE
TV /DBS
B
D
B
TIMER RECORDING (cont.)
This VCR can perform D-VHS recording of a program
which is timer-programmed on your Integrated HDTV (or
Digital Set Top Box).
A
Load a D-VHS cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before inserting
the cassette.
•
The [D-VHS] LED on the front panel and [D-
VHS] indicator on the front display panel light
up and the D-VHS recording mode is enabled.
B
Select recording channel (i.LINK
input)
On the front panel:
Press [CHANNEL +] or [–] to select "I-1" etc.
On the Remote:
Press [TV/VCR CH +] or [–] to select "I-1" etc.
•
Set "LINC" to "AUTO". (A page 70)
C
Set timer program on the Inte-
grated HDTV source
•
Confirm that a link has been established
between this VCR and the Integrated HDTV.
•
Set the recording speed to "AUTO" if this option
is available.
•
For timer programming method, refer to the
manual of the Integrated HDTV.
D
Engage recording standby mode
Press [POWER] to turn off the VCR.
•
The Integrated HDTV will activate the VCR to
automatically start recording through i.LINK at
the programmed time.
•
The VCR may not record a short portion at the
beginning of the program, to ensure full
recording of the program, turn on the VCR
slightly before the programmed time.
ATTENTION:
When this VCR is connected via i.LINK to a TV or a Digital
Set Top Box, there may be cases when the images are not
recorded by the VCR. In such cases, choose the record
command from the i.LINK menu of the TV or the Set Top
Box.