JVC Exad KD-ADV38 Instructions Manual page 380

When using the optional stay
Dashboard
Removing the unit
Before removing the unit, release the rear section.
A
Connecting the parking brake lead
Connect the parking brake lead to the parking brake system built in the car.
Parking brake
B
Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL)
Locate the reverse lamp lead in the trunk.
Reverse lamp lead
C
Connecting the Mic unit
1
Microphone
Microphone clip
Stay (option)
Fire wall
Screw (option)
30˚
Install the unit at an angle of less than 30˚.
Parking brake switch (inside the car)
Reverse lamps
2
Secure the microphone cord using cord cramps (not supplied) if necessary.
When installing the unit without using the sleeve
In a car having the "Required space for installation" (see page 1), first remove the car radio and install the
unit in its place.
2
Flat type screws—M5 x 8 mm *
2
Bracket *
* 2
Bracket
Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the unit.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
To reverse lamp
Reverse lamp lead
or
2
* 2 Not included for this unit.
Flat type screws—M5 x 8 mm * 2
Parking brake lead (light green)
To metallic body or chassis of the car
Purple with white stripe
To car battery
J
Double-sided adhesive tape
Adjust the microphone angle