Correcting Minor Faults - Miele H 310 Operating Instructions Manual

Installation, maintenance and repairs
to the electrical components of this
appliance should only be carried out
by a suitably qualified and compe-
tent person in accordance with local
and national safety regulations. Re-
pairs and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held re-
sponsible for unauthorised work.
Some minor problems however can be
dealt with as follows:
What to do if . . .
. . . the hob cooking zones / hotplates
do not warm up after being switched
on.
Check whether,
^ the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . the oven does not heat up.
Check whether,
^ the selector switch is set to the func-
tion required, and the temperature
control is set at the correct tempera-
ture.
^ "AUTO" is lit up in the timer display
field.
To switch on the oven independently
of the timer, "l" should show in the
display. Press the "i" button.
^ the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.

Correcting minor faults

. . . the heating works, but not the
oven lighting.
The lamp needs changing:
^ Disconnect the appliance from the
electricity supply: Switch off at the
isolator or the mains fuse box.
^ Unscrew the light cover and the seal.
^ Change the lamp: 230-240°V, 25 W,
E 14, heat resistant to 300°C.
^ Screw the light cover and the seal
back on again.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
. . . a noise can be heard after baking,
roasting or grilling.
This is not a fault. The cooling fan con-
tinues to run for a while after the oven
has been switched off to prevent any
humidity building up in the oven, on the
control panel or in the oven housing
unit. When the temperature has fallen
sufficiently the fan switches off automat-
ically. The temperature will fall faster
when the oven door is opened partially
or fully.
57