14
AP-7131 Series Access Point: Installation Guide
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the access
point's GE1/POE or GE2 port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the access point.
e. Attach the power supply line cord to a power supply.
CAUTION
5. Verify the behavior of the access point LEDs. For more information, see "
on page 19.
6. Align the bottom of the ceiling T-bar with the back of the access point.
7. Orient the access point chassis by its length and the length of the ceiling T-bar.
8. Rotate the access point chassis 45 degrees clockwise.
9. Push the back of the access point chassis on to the bottom of the ceiling T-bar.
Do not actually connect to the power source until the cabling portion
of the installation is complete.
LED Indicators
"