Fan Belt Tension Adjustment - TATA Motors Sumo Victa EX Owner's Manual

BELT TENSION ADJUSTMENT

Fan belt tension adjustment

Check the conditions of belts on the engine. Examine the
edge of the belt for cracks or fraying.
Check the tension of the belt by pushing on it with your
thumb for A.C. compressor belt and Alternator / Power
FAN PULLEY
TENSION
ADJUSTMENT
BOLT
ALTERNATOR
PULLEY
TENSION
ADJUSTMENT
A.C. COMPRESSOR
BOLT
PULLEY
TENSIONER
TENSIONER
VIBRATION DAMPER POWER STEERING
PULLEY PUMP PULLEY
Belt Arrangement - Engine with AC compressor
and power steering pump
V E H I C L E M A I N T E N A N C E
Steering belt as shown in schematic diagram.
The belts should have deflection of 8 to 10 mm.
If the belt tension is not proper, get it attended at the nearest
Authorised service outlet.
FAN PULLEY
A.C. COMPRESSOR
PULLEY
TENSIONER
AC BELT TENSION
ADJUSTMENT NUT
VIBRATION DAMPER PULLEY
Belt Arrangement - Engine with AC compressor
and without power steering pump
64
V E H I C L E M A I N T E N A N C E
Bleeding clutch system
A dry friction, single disc, diaphragm type clutch has been fitted
which is actuated hydraulically.
The procedure for bleeding the system is as follows :
a. Ensure that fluid level in clutch fluid container is upto
maximum level.
b. Remove dust cap from slave cylinder bleed screw and clean
ALTERNATOR
the screw thoroughly. Attach bleeding tube to bleed screw
BELT TENSION
and place other end of tube in a clean glass jar containing
ADJUSTMENT NUT
sufficient clutch fluid to submerge tube end.
c. Pump clutch pedal twice or thrice slowly throughout its
stroke and by holding clutch pedal in depressed condition,
loosen bleed screw on slave cylinder, Watch for air bubbles in
glass jar.
d. Retighten bleed screw on slave cylinder and repeat the
process until air bubbles cease to appear at the end of tube in
glass jar, allowing only fluid to flow.
ALTERNATOR
PULLEY
e. After completing bleeding operation, ensure that bleed
screw on slave cylinder is fully tightened. Replace dust cap on
the bleed screw.
During bleeding process keep a watch on fluid level in
container and top-up.
BLEEDING CLUTCH SYSTEM
Clutch Fluid Container
Bleeding clutch slave cylinder
Bleeding clutch slave cylinder
65