Miele HM 5316 User Manual page 5

Notes on the use of this machine
– This ironer must be operated at all times in
accordance with the legal requirements of
the Health and Safety Acts.
– Please allow only trained persons,
thoroughly familiar with the ironer, to work
at the feed-in. Always conform to local and
national regulations on minimum age
requirements of operators.
– Persons with especially slim fingers should
only work at the receiving side and not at
the feed-in.
– When working with the ironer, always wear
close fitting clothes. Wide sleeves, apron
bands, ties or scarves could be taken in
by the roller. Also remove rings or
bracelets before starting to work.
– Smooth out folds as far away as possible
from the feed-in on the feed-in table. Feed
pillow cases and duvet covers into the
ironer with the open part first. Do not take
hold of the corners from the inside. Do not
take hold of undershirt and apron straps
from the inside.
– Always check the proper setting of safety
devices. This way you will avoid the
danger of burns, squashed fingers and
even loss of hands.
– Check daily whether the safety devices
function properly.
– Make sure that the safety bars cannot be
bridged.
– Before switching to reverse make sure that
nobody is endangered.
– Lubricate machine parts only when the
machine is shut off.
All personnel working with this machine must
be fully trained in all aspects of its use and
safety.
Keep these instructions in a safe and
accessible place.
M.-Nr. 06 017 102
Warning and safety instructions
5