Electrical Connection - Miele HM 5316 User Manual

Electrical connection

Electrical connection
This machine conforms to IEC 335-1 and
IEC 335-2-44.
The electrical connection may only be
carried out by a suitably qualified technician
in accordance with local and national safety
regulations (BS 7671 in the UK).
WARNING
THIS APPLIANCE MUST BE EARTHED
Connection to the electrical supply must be
carried out in accordance with the data
plate, wiring diagram, installation diagram
and, where applicable, the conversion
instructions.
The wiring diagram can be found under the
cover plate of the right hand side of the
machine.
The machine is supplied 3N~ ex works.
Please ensure that the voltage and
frequency of the machine as quoted on the
data plate comply with the on-site supply.
If it is converted to another voltage, the data
place should be marked with a D.
,
The heater plate is disengaged as
soon as current is supplied.
18
Connection should be made via a suitable
isolator which complies with local and
national safety regulations and which is
easily accesible for disconnecting the
machine from the electricity supply.
Provision must be made on site to switch off
all poles. Switches with a minimum all-pole
contact gap greater than 3 mm are suitable
for isolating the machine. These include
circuit breakers, fuses and relays (IEC/EN
60947).
The isolator switch should be easily
accessible for servicing work.
If the machine is disconnected from the
electricity supply ensure adequate measures
are taken to ensure that the machine cannot
be reconnected to the electricity supply until
all work has been carried out.
The ironer must be disconnected from the
electricity supply before it is moved or
dismantled.
,
After setting up and connecting the
machine successfully ensure that the
machine is earthed and that all removable
outer panels are correctly fitted back into
position.
M.-Nr. 06 017 102