Remote controlling heaters
To use ARS (Automatic Response System) for remote heater control
1
Call the desired phone number.
● When the call is not answered for a specific time
(usual case: 30 seconds, away mode: 10 seconds),
it is switched to the remote control mode.
4
If the following announcement is
heard, press [1].
"The
is off.
boiler
Enter the 1 button to turn on
"
the boiler.
● When the heaters are turned on, the message,
"The
is on.
boiler
Enter the 0 button to turn off the
." is heard. To turn them off, press [0]." Or
boiler
hang up the phone.
6
2
If the following announcement is
heard, press the 4-digit [Password].
"Enter the
password."
●
At this time, use the disengagement password.
5
To end the remote control, press any
button except
[0], [1],
"The boiler has been turned on.
Enter the 0 button to control the light.
Enter the 1 button to control the gas valve.
Enter the 2 button to control the curtain.
Enter the 3 button to control the boiler. "
●
To end the function, hang up the phone.
●
To control the gas valve, press [1].
●
To control the curtain, press [2].
●
To control the heater, press [3].
All heaters can be turned on or off at once.
●
If no button is presses for 20 seconds, the phone is automatically disconnected.
●
Note
When a phone with the answering machine is installed, the remote control function
●
may not operate depending on the automatic response interval setting.
For setting the password, see page 70.
●
To use ARS for remote heater control, the disengagement password has to be
●
registered and ARS has to be activated. (see page 73)
3
If the following announcement is
heard, press [3].
"Enter the 0 button to control the light.
Enter the 1 button to control the gas valve.
Enter the 2 button to control the curtain.
Enter the 3 button to control the boiler. "
6
If the following announcement is
[2], and [3].
heard, hang up the phone.
"Setting is completed."
●
After 5 or 6 seconds, the phone is automatically
disconnected.