Remote-Controlling Lights - Samsung SHT-8610 User Manual

Remote-controlling lights

To use ARS (Automatic Response System) for remote light control
1
Call the desired phone number.
●
When the call is not answered for a specific time
(usual case: 30 seconds, away mode: 10 seconds),
it is switched to the remote control mode.
4
If the following announcement is
heard, press [1].
"The lights is off.
Enter the 1 button to turn
on the light."
● If any light is turned on, the message, "The
lights is on.
Enter the 0 button to turn off the light." is heard.
To turn them off, press "0." Or hang up the
phone.
2
If the following announcement is
heard, press the 4-digit [Password].
"Enter the
password."
●
At this time, use the disengagement password.
5
To end the remote control, press any
button except [0], [1], [2], and [3].
"The light has been turned on.
Enter the 0 button to control the light.
Enter the 1 button to control the gas valve.
Enter the 2 button to control the curtain.
Enter the 3 button to control the boiler. "
● To end the function, hang up the phone.
● To control the gas valve, press .
[1]
● To control the curtain, press .
[2]
● To control the heater, press .
[3]
● If no button is presses for 20 seconds, the phone is automatically disconnected.
● When a phone with the answering machine is installed, the remote control function
Note
may not operate depending on the automatic response interval setting.
● For setting the password, see page 70.
● All lights are turned off or on at once.
● To use ARS for remote light control, the disengagement password has to be registered
and ARS has to be activated. (see page 73)
3
If the following announcement is
heard, press [0].
"Enter the 0 button to control the light.
Enter the 1 button to control the gas valve.
Enter the 2 button to control the curtain.
Enter the 3 button to control the boiler. "
6
If the following announcement is
heard, hang up the phone.
"Setting is completed."
● After 5 or 6 seconds, the phone is automatically
disconnected.
3