1.4 Ghz Default Ap Configuration Worksheet; Setting Descriptions; Blank Template - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Chapter 2: Planning Your ITS Deployment

1.4 GHz Default AP Configuration Worksheet

Refer to the following setting descriptions when completing the 1.4 GHz Access
Setting
Descriptions Point Configuration Worksheet.
• Partnered APC - "Any"
• Default Group - Always Smart-hopping.
• WMTS Channels - Circle the WMTS Channel that will be used for this
installation. Default range = 1 to 6. Note: Disable channels 4, 5 & 6 when
Special Geographic Area is selected - use channels 4a, 1, 2 and 3.
• RF Access Code - Enter number between 1 and 254 to be used as the Access
Code for the system (site specific). Do not use 0 or 255, these are reserved for
special use. For use of multiple RF Access Codes, refer to Appendix A, "Installing
Multiple ITSs at a Single Hospital Site."
• IP Addressing: Subnet Mask - Enter the Static Subnet Mask documented for the
APC Configuration.
• IP Addressing: Default Gateway - Enter the Static Default Gateway documented
for the APC Configuration.

Blank Template

Settings
Partnered APC
Default Group
WMTS Channels
RF Access Code
IP Addressing: Subnet mask
IP Addressing: Default gateway
2-32
Rules
Circle channels at right.
Enter any number from 1 to 254 at
right. (not 0 and not 255)
[Copy from APC Configuration]
[Copy from APC Configuration]
Value
Any
Smart-hopping
Standard: 1 2 3 4 5 6
Special: 4a
1 (Site Specific)