Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for DeWalt DW701
Summary of Contents for DeWalt DW701
- Page 1 ® DW701 DW707...
- Page 2 Dansk Deutsch English Español Français Italiano Nederlands Norsk Português Suomi Svenska Türkçe EÏÏËÓÈη Copyright D WALT...
-
Page 3: Components View
17 18... - Page 4 25 26 27 29 26 27 25...
- Page 5 48 45 51 50 49...
- Page 6 45°...
- Page 7 E N G L I S H CROSS-CUT MITRE SAW DW701/DW707 Congratulations! EC-Declaration of conformity You have chosen a D WALT product. Years of experience, thorough product development and innovation make D WALT one of the most reliable partners for professional users.
- Page 8 E N G L I S H Safety instructions 17 Do not abuse cord When using Power Tools, always observe the safety regulations Never carry the tool by its cord or pull it to disconnect from the socket. applicable in your country to reduce the risk of fire, electric shock Keep the cord away from heat, oil and sharp edges.
- Page 9 E N G L I S H Package contents The package contains: 31 Legstand 1 Partly assembled machine 33 Roller table 1 4 mm Allen key Electrical safety 1 6 mm Allen key 1 216 mm TCT saw blade The electric motor has been designed for one voltage only. Always check 2 Coach bolts that the power supply corresponds to the voltage on the rating plate.
- Page 10 E N G L I S H Assembly Adjustment Prior to assembly always unplug the tool. Prior to adjustment always unplug the tool. The motor and guards are already assembled onto the base. Your Mitre Saw was accurately adjusted at the factory. If readjustment due to shipping and handling or any other reason is required, follow the steps below to adjust your saw.
- Page 11 5 = 5,000 min Vertical mitre cross-cut (fig. A2 & N) • Loosen the mitre clamping knob (12) and lift the positive stop lever (11) DW701/DW707 upwards (fig. A2). • To turn the saw ON, press the trigger switch (1) while squeezing the •...
- Page 12 E N G L I S H When mitring the end of a piece of wood with a small off-cut, Clamping the workpiece (fig. A3) position the wood to ensure that the off-cut is to the side of Always use a material clamp when cutting non-ferrous metals. the blade with the greater angle to the fence: •...
- Page 13 E N G L I S H Cutting non-ferrous metals GUARANTEE When cutting non-ferrous metals, the machine is only to be used to perform vertical straight and mitre cross-cuts in the mitre saw mode. • 30 DAY NO RISK SATISFACTION GUARANTEE • We recommend that bevel and compound mitre cuts should not be If you are not completely satisfied with the performance of your performed in non-ferrous metals.
- Page 14 Belgique et Luxembourg WALT Tel: 02 719 07 12 België en Luxemburg Weihoek 1, Nossegem Fax: 02 721 40 45 1930 Zaventem-Zuid Service fax: 02 719 08 10 Danmark WALT Tlf: 70 20 15 10 Hejrevang 26 B Fax: 48 14 13 99 3450 Allerød Deutschland WALT...