Final Gear Oil - Suzuki AN400 Service Manual

2-10 PERIODIC MAINTENANCE
• Install the new O-ring 3 and spring 4 to the oil filter cap.
NOTE:
* Before installing the oil filter cap, apply engine oil lightly to the
new O-ring 3.
* The triangle mark A on the oil filter cap should be positioned
topward.
# Oil filter cap bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
$ Engine oil capacity
Oil change: Approx.1 900 ml (64.22/66.90 US/lmp oz)
Filter change: Approx.2 000 ml (67.60/70.42 US/lmp oz)
Overhaul engine: Approx.2 300 ml (77.74/80.98 US/lmp oz)

FINAL GEAR OIL

Replace every 12 000 km (7 500 miles, 12 months) the-
reafter.
TRANSMISSION OIL REPLACEMEMT
• Keep the motorcycle upright with the center stand.
• Remove the left side leg shield. (!7-15)
• Remove the clutch cover 1. (!3-16)
• Place an oil pan below the mission case.
• Remove the oil level plug 2 and inspect the oil level. If the
level is below the level hole, add oil until oil flows from the
level hole.
& Oil viscosity and classification
• Tighten the oil level plug 2 to the specified torque.
# Oil level plug: 12 N·m (1.2 kgf-m, 8.5 lb-ft)
NOTE:
If oil is dirty with sludge or used for a long period, drain the oil by
removing the oil drain plug 3 and pour fresh oil through the oil
level hole.
# Oil drain plug: 12 N·m (1.2 kgf-m, 8.5 lb-ft)
$ NECESSARY AMOUNT OF FINAL GEAR OIL
Oil change: Approx.190 ml (6.42/6.69 US/lmp oz)
Overhaul: Approx.200 ml (6.76/7.04 US/lmp oz)
:SAE 10 W-40 with SF or SG