Water softener
^ Wipe any residual salt off the screw
threads and seal of the reservoir.
^ Screw the cap on securely.
^ Immediately after this step, start the
"Rinse" program, to remove any
traces of salt from the inside of the
lab washer.
Note: There may be a delay of a few
minutes before the "Rinse" program
starts due to the reactivation of the
water softener.
16
Salt indicator
When the salt reservoir is empty, the
"Recharge Softener" indicator b lights
to remind you to fill the reservoir.
Reactivation takes place automatically
as needed during a program. The
"Recharging" indicator a lights while
this is occurring.