Front Differential - BOMBARDIER Traxter 7400 Shop Manual

Drive Shaft Boot
Removal
Remove:
– clamps from rubber boot using boot clamp pli-
ers (P/N 295 000 069 and 295 000 054)
– large end of the boot from plunging joint or CV
joint
Move apart circlip and pull out the shaft from bear-
ing. Do not remove circlip.
1. Circlip
2. Shaft
Remove boot from drive shaft.
Inspection
Check bearing in plunging joint or CV joint. If bear-
ing is hard to move, change plunging joint or CV
joint.
Check circlip for damage, change as necessary.
Installation
For installation, reverse the removal procedure.
Paying attention to the following details.
Insert boot, do not forget the small clamp.
Insert shaft and push firmly.
Pack bearing area with grease (including with the
new boot kit).
NOTE: Do not use an other grease
Subsection 02 (FRONT DIFFERENTIAL)

FRONT DIFFERENTIAL

Removal
Raise front of vehicle, support it securely on jack
stands and remove front wheels.
Remove:
– skid plate
– winch protector
– front bumper
– inner fender
Refer to BODY 10-02 for the proper instructions.
On LH side, remove:
– wheel cap no. 13
– cotter pin no. 12
– castellated nut no. 11
– flat washer no. 10
– O-ring no. 21
On front side, remove:
– differential mounting bracket bolt
– front mounting bolt no. 3
– rear mounting bolt no. 5
– differential bracket no. 22
– mounting bracket no. 2
.
1. Front mounting bolt M10 x 200
2. Differential mounting bracket bolts
3. Bracket
4. Rear mounting bolt M10 x 60
http://ReadManuals.com
Section 06 DRIVE TRAIN
06-02-3