BOMBARDIER Traxter 7400 Shop Manual page 135

Section 05 ELECTRICAL
Subsection 06 (ELECTRIC SHIFT SYSTEM)
Task 2: Clutch Modulator Calibration
The LED "Check Engine" blinks for a maximum time of 5 seconds or until the user begins the calibration
process or removes the jumper.
The upshift/downshift button is used to change the calibration of the clutch modulator valve. When one
of these buttons is activated, the LED "Check Engine" stops to blink and goes ON. The corresponding
LEDS are turned ON according to the calibration (See table below).
Table 1: Corresponding Clutch Modulation Calibration
GEAR LED
HARDNESS SMOOTHNESS
1 1 + 2 2 2 + 3 3 3 + 4 4 4 + 5 5
If the upshift/downshift button is not activated during the time the LED "Check Engine" blinks, the MPEM
goes to the next task. Run vehicle to verify if the calibration is OK. The jumper needs to be removed and
the key turned OFF and back ON before running the vehicle with the new calibration.
05-06-4
http://ReadManuals.com