Panasonic KX-NCP500 Networking Manual page 48

4.3.1 Assigning the IP Addressing Information
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
For KX-NCP500/KX-NCP1000/KX-TDE100/
KX-TDE200, type the IP address of the MPR card
in the IP Address for IPCMPR Card box. For
KX-TDE600, type the IP address of the MPR card
in the IP Address for IPCEMPR Card box.
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP card.
d.
In the Subnet Mask box, type the subnet mask
address of the network.
e.
In the Default Gateway box, type the IP address
of the default gateway.
f.
Click Apply.
8. Follow the instructions of the Quick Setup wizard in Quick Setup.
After Quick Setup is completed, if the IP addressing information was not changed and a V-IPEXT card
was installed during setup, the IP-PT registration screen is displayed. For information on registering
IP-PTs to the PBX, refer to "Registration of IP-PTs" in "4.6.1 Registering IP Telephones".
Programming from the system menu
1. The IP addressing information for the MPR card can
also be assigned from the system menu.
a.
Under Configuration, click Slot.
b.
Move the mouse pointer over the MPR card. A
menu will be shown under the mouse pointer.
c.
Click Card Property.
2. When using a DHCP server:
a.
Click the LAN Setting tab, then select Enable for
the DHCP Client setting.
b.
Click Apply.
48 IP Networking Guide
*1
*2
*3
*4
Document Version 2010-08