Lenovo 8200 Series Installation Manual page 59

1. Log in to the server that contains installed 8200 Series Adapters.
2. Open the Server Manager and select Diagnostics > Device Manager > Network Adapters.
3. Right-click the first QLogic 10 Gigabit Ethernet CNA device and select Properties from the context
menu (Figure 41).
4. Click the Team Management tab.
5. In Teams and Adapters, click Teams, and then click Custom Settings.
The Teaming custom settings dialog box displays (Figure 19).
Figure 19: Enabling LACP
6. Select the Allow 802.3as team over CNA check box, and then click OK.
The network must be configured to a Cisco-supported configuration, as described in the following
paragraphs. This information is from the Cisco support forum thread,
https://supportforums.cisco.com/thread/2071713.
A virtual fabric channel (vFC) can be bound inside a virtual port channel (vPC) because the Cicso Nexus
5x00 (FCF) sees only one link.
8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter
®
41
Page