Quick Start; Step 1. Install The Adapter Hardware - Lenovo 8200 Series Installation Manual

Quick Start

This Quick Start section describes how to install and configure your new QLogic converged network
adapter in three simple steps:

• Step 1. Install the Adapter Hardware

• Step 2. Install the Adapter Drivers
• Step 3. Install QConvergeConsole
• Step 4. Update the Flash
Caution: Keep the adapter in the antistatic bag until installation. The adapter contains parts that can
be damaged by electrostatic discharge (ESD). Before handling the adapter, use standard
methods to discharge static electricity. Place the adapter on the bag when examining it.
Retain the bag for future use.
Step 1. Install the Adapter Hardware
To install the adapter hardware, you need to open the computer and locate the appropriate bus slot. If
necessary, consult your computer system manual for instructions on how to remove the computer cover.
Follow these steps to install the adapter hardware:
1. Power off the computer and all attached devices such as monitors, printers, and external components.
2. Disconnect the power cable.
3. Remove the computer cover and find an empty PCIe
4. Pull out the slot cover (if any) by removing the screw or releasing the lever.
5. Install the low-profile bracket (if required).
6. Grasp the adapter by the top edge and seat it firmly into the appropriate slot (see Figure i).
ADAPTER
RETAINING
BRACKET
SLOT COVERS
Figure i Illustration of Server Motherboard and Slots
7. Refasten the adapter's retaining bracket using the existing screw or lever.
8. Close the computer cover.
9. Plug the appropriate Ethernet cable (either copper or optical) into the adapter.
8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter
®
LEVER
SCREW
SYSTEM
CHASSIS
®
x8 (or larger) bus slot.
ADAPTER
PCI EXPRESS x8
(OR LARGER) SLOT
REQUIRED FOR
QLOGIC ADAPTERS.
Page
xv