Initializing The Voice Mail; Installing The Phone System - NEC VANGARD i-Series Quick Setup Manual

Vangard i-series;

Hide thumbs

Table Of Contents

Table of Contents

Initializing the Vo ice Mail

Installing th e Phone System

Initializing the Voice Mail for Your Phone System

Installing the Phone System

Chapter 4: Voice Mail Programming

If this is a new installation, you must specify the i-series in Voice Mail programming as the phone

system that you actually connected to the VANGARD. If this is not a new installation, and you sim-

ply installed additional port cards, skip this part and go to "Required Programming for the Voice

Mail Ports" on page 34.

To install the phone system in the Voice Mail:

This option is also available on the Database Management Menu. See

System Initialization (SI) and Power Down (DP) in "Using the

Options on the Database Management Menu" in Chapter 3 of the VAN-

GARD System Guide.

Turn on the laptop or other computer, and access the communications software.

When the computer is communicating with the Voice Mail, you will see the MAIN MENU ->

prompt.

At the MAIN MENU -> prompt. press IN and then Enter.

Enter the password (the default password is CTL), if requested and press Enter.

The Install System Menu will be displayed. Each phone system on this menu corresponds to a

number in the column at the left.

Note: The Menu shown below is for software versions 9.08. Lower versions of software do not have

the DS2000 phone system listed on the INSTALL SYSTEM Menu.

******* INSTALL SYSTEM Menu *******

Press command below,

then press Enter:

Press 5 (the number that corresponds to the i-Series) as the phone system to be installed in the

Voice Mail.

Press Enter.

Follow the instructions on your Voice Mail screen.

For information about integrating the i-Series with the Voice Mail, see "Chapter 3: Phone Sys-

tem Programming" on page 27.