Force Adjustment Guide - Overhead door Odyssey 1000 7030H Operation And Maintenance Manual

ADJUSTMENT GUIDE
Door closing force is FACTORY set and requires no
adjustment for normal operation.
• Never increase the door closing force to
compensate for a damaged door or a binding
door track.
• Never adjust force to compensate for a broken
door spring.
• Perform monthly CONTACT REVERSE TEST as
described on page 18.
Force settings are pre-programmed at the factory
and "learned" during the Open/Close Limit settings
steps. Some additional Force may be increased.
For normal use, Force settings should not need
adjustment with this unit.
However, conditions that might suggest an
adjustment is necessary are;
Doors with very stiff weather seals.
Doors that start down, then STOP and reverse
before they close.
Doors that start up, but STOP before they
completely open.
Default LED display is the current Force setting
LED indicator colors
Force Level 1
Force Level 2
Force Level 3
Force Level 4
Force Level 5
Force Level 6
Force Level 7
Force Level 8
Force Level 9
©2010 Overhead Door Corporation
- FORCE SETTINGS
CAUTION
Force Level
FOR HELP-1.800.929.3667 OR WWW.OVERHEADDOOR.COM
CHANGE FORCE SETTING
Use this guide to ADJUST powerhead FORCE settings.
NOTE: There are nine (9) force levels.
PROGRAM
1. Press
SET
lights turn steady ON. Release button.
Lights go out and Round BLUE light comes ON.
2. Press
PROGRAM
3. Press
SET
menu. The round LED will flash BLUE 3 times,
then the current Force setting for UP force will
display on the LEDs. See table below.
4. (If current UP Force setting is good, skip to Step
5.) Press
settings within the available range.
PROGRAM
5. Press
SET
flash BLUE 3 times, then the current Force setting
for DOWN force will display on the LEDs.
6. (If current DOWN Force setting is good, skip to
Step 7.) Press
DOWN Force settings within the available range.
PROGRAM
7. Press
SET
BLUE to confirm.
OFF, Blue, Purple,
12/2010
on the powerhead and hold until both
three times, Round RED light comes ON.
once to enter the Force Programming
to increase or to decrease UP Force
to set UP Force level. The long LED will
to increase or
to set DOWN Force level. Both LEDs flash
Powerhead LEDs
Round LED
Red
Force Level LED indicator colors
Blue
ON
OFF
Blue
ON
Purple
ON
OFF
Purple
ON
Red
ON
OFF
Red
ON
to decrease
Long LED
OFF
Blue
ON
Blue
ON
OFF
Purple
ON
Purple
ON
OFF
Red
ON
Red
ON
23