Mitsubishi Electric Jet Towel JT-MC106G-W-NA Installation Manual page 8

Installation method - continuation
1. Remove the drain tank.
2. Open the front cover and remove the
air fi lter.
Refer to "How to open/close the front cover"
(Page 13).
3
3. Remove the main unit panel
mounting screw (1).
4. Unlock the upper tabs (2 locations)
of the main unit panel, and remove
the main unit panel from the base.
5. Remove the terminal block cover
mounting screw (1), and remove the
terminal block cover.
Be careful not to lose the cord bushing.
1. Push the power cable for exclusive
wiring through the power cord hole
at the rear of the base.
4
2. Engage the base with the 2 hooks on
the installation panel.
3. Check that the power cable is not
trapped behind the base.
Air fi lter
Open
Pull the tab and open the front
cover.
Pull the tab and open the front
cover.
Front cover
Main unit panel
mounting screw
Terminal
block cover
mounting
screw
Terminal block cover
Power cord hole
Ground wire
Panel hooks
(2 locations)
Installation
panel
NA 8
Drain tank
Tab
Air fi lter
Tab
Main unit panel
Base
Base
Cord bushing
Ground wire
Power cable
Power cable
Power cord hole
Main unit
panel
Main
unit panel
Base
Tab
Base