Mitsubishi Electric Jet Towel JT-MC106G-W-NA Installation Manual page 10

Installation method - continuation
1. Place the power cable through the
cord bushing and reattach it to the
circuit case with the terminal block
cover mounting screw.
6
2. Check that the power cable and wires
are not pinched anywhere.
1. Insert the "Motor lead wire" into the
gap of ribs on the Base.
Caution
Check to see that the "Moter lead wire" is
fitted to the gap of ribs.
2. Insert the tabs (2 locations) of the
main unit panel into the locks of the
base hooks and fi x it with screw (1).
The screw is inside the front cover.
3. Check that the 2 hooks on the main
unit panel are hooked in the base.
4. Gently press the unit against the wall,
7
and fi x it in place using 2 accessory
mounting screws (5 30).
When installing on a concrete wall, use
commercially available metal screw plugs with
the procedures below before fixing the front
cover onto the base.
Temporarily place the main panel on the
base.
Mark the position of the hole in the wall
through the mounting screw hole with a
pen.
Remove the main unit panel and insert
commercially available metal screw plugs
into the marked locations of the wall.
Reinforce any walls made with materials other
than concrete before installation.
Base
Main unit panel
Tab
Base
Base
Main unit panel
Plug positioning
Mounting screws
Mark the wall in
(5 30)
2 places
(Accessories)
NA 10
Terminal block
cover mounting
screw
Terminal
block cover
Cord
bushing
Pull the tab for opening the
front cover.
Tab
Front cover
Main unit panel
mounting screw
Main unit
panel
Installation
hole
Mounting screws
(5 30)
(Accessories)
Plugging marks
on the wall