Speaker Layout - JVC DD-8 Instructions Manual

Preparation (continued)
Connecting the subwoofer to the
main unit
Only for DD-8 and DD-3
Peel off the protective sheets
Subwoofer
from both sides of the sub-
woofer.
Rear view
System cable (supplied)
Align the 5 marks on the terminals and the sys-
tem cable.

Speaker layout

Center surround speaker
Left speaker
11
Do not turn on the power until you complete the connection.
Main unit
Rear view
Right speaker
Subwoofer
■ CAUTION
• An incorrect connection may damage the speak-
ers. Properly connect the cables to the speaker
terminals.
• Do not short-circuit the ª and · speaker termi-
nals. Doing so may damage the main unit.
• The supplied speakers are manufactured exclu-
sively for use with the supplied main unit as
parts of the DD-8/DD-3/DD-1 system. Do not
connect the supplied speakers to devices other
than the supplied main unit. Doing so may dam-
age the speakers.
• Do not connect other speakers together with the
supplied speakers. The change in impedance
may damage the main unit and the speakers.
• Improper speaker cable connection spoils the
stereo effect and sound quality.
• Most of the supplied speakers* are magnetically
shielded, but color irregularity may occur on the
TV depending on some conditions. To prevent
color irregularity, set up the speakers following
the instructions below.
1. Turn off the main power of the TV before
setting up the speakers.
2. Place the speakers enough distance from the
TV so that they do not cause color irregularity
on the TV.
3. Wait for approximately 30 minutes before
turning on the main power of the TV again.
* The subwoofers for DD-3 and DD-1 are not
magnetically shielded. With the exception of
these 2 subwoofers, the supplied speakers
are magnetically shielded.