Page 1
USER GUIDE Barometric Pressure / Humidity and Temperature Datalogger Model SD700...
Page 2
Introduction Congratulations on your purchase of the Extech SD700 Humidity/Barometric Pressure/Temperature Datalogger. This meter measures, displays, and stores the measured data over time storing the information on a SD card which can then be downloaded to a PC. This meter is shipped fully tested and calibrated and, with proper use, will provide years of reliable service.
Page 3
LOG (ENTER) button SET button AC adaptor socket Sensors ▲(TIME) button ▼ button 10. Reset button 11. RS-232 output 12. SD memory card socket Note: Battery Compartment and Tilt Stand are located on the back of the meter. SD700-EU-EN V2.4 07/13...
Page 4
Note: To protect data, do not remove the memory card without properly ending the record function. Time/Date/Sample Rate Check Press and Hold the TIME button for >2 seconds and the display will cycle through the date, time and sample rate information. SD700-EU-EN V2.4 07/13...
Page 5
Remove the memory card from the datalogger and plug it into the SD card slot on the PC. Launch Excel® and open the data file on the memory card from within the spreadsheet program. The file will appear similar to the one shown below. SD700-EU-EN V2.4 07/13...
Page 6
RESET button on the side of the datalogger (use a paper clip or similar pointed object) to return the meter to a working state. RS232 Interface A serial output is provided to link the meter to a PC’s serial port. Call Technical Assistance for more information on this interface. SD700-EU-EN V2.4 07/13...
Need help?
Do you have a question about the SD700 and is the answer not in the manual?
Questions and answers