Table of Contents
Advertisement
TM
11. Turning SureFlap
In the event that you want to turn SureFlap
flap then follow the four steps below:
1.
Remove the battery cover and make sure batteries are installed.
2.
Press the memory button once to put the SureFlap
mode. The latch will open and the indicator lamp will flash.
3.
Remove the batteries and replace the battery cover.
4.
The latch will stay open and SureFlap
standard cat flap.
This mode may be useful if you have purchased SureFlap
has been microchipped or while your cat is getting used the presence of their
new cat flap (see trouble shooting guide).
12. Maintenance
The sensor that detects the presence of a cat in the tunnel is optical and is
situated on the inside roof of the tunnel, close to the flap. The position of the
sensor is shown in figure 28. If these lenses become obscured by dirt then
unreliable operation and/or shortened battery lifetime may result. Wipe these
lenses with a damp cloth every couple of months.
Operation of the sensor relies on a reflection from the base of the tunnel,
which should also be kept reasonably clean.
TM
After cleaning, leave SureFlap
for approximately 10s for the unit to settle
before normal operation returns.
Page 18
Off
TM
off and revert to a standard cat
TM
into learn
TM
can now be used as a
TM
before your cat
Optical sensor
lenses
Figure 28
Page 19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MICROCHIP CAT FLAP and is the answer not in the manual?
Questions and answers
If the batteries run out & I don't realise for a while will I need to reprogramme my cats microchip when new batteries are inserted?
No, you do not need to reprogram the SureFlap Microchip Cat Flap after replacing the batteries. The memory retains stored microchip codes even when the batteries are removed.
This answer is automatically generated
My SureFlap has stopped working. It is not reading my cats microchip. I have changed the batteries & done a reset as per instruction manual. The light flashes when it has been reset but goes out when cat enters but still doesn't work. It has been installed for aprox 7yrs. Can you help please?
The SureFlap Microchip Cat Flap may not be reading your cat's microchip because the memory was accidentally reset when replacing the batteries. If the small button next to the battery compartment was pressed during battery replacement, the stored microchip data would be erased. In this case, you need to reprogram the cat flap to recognize your cat's microchip again.
This answer is automatically generated
@Mr. Anderson As explained it stopped working so I changed the batteries, presented my microchipped cat while the light flashed and it didn't work. I then reset the flap and the red light flashed, I then presented my cat again , the light stopped flashing but still did not operate. Is there anything else I can try?