Assembly And Adjustments; Operation - DeWalt D25580 Instruction Manual

These demolition hammers are professional power tools.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and
disconnect machine from power source before installing and
removing accessories, before adjusting or changing set-ups
or when making repairs. Be sure the trigger switch is in the OFF
position. An accidental start-up can cause injury.
Inserting and Removing Chisels (fig. 2)
WARNING: Always wear gloves when you change accessories.
The exposed metal parts on the tool and accessory may become
extremly hot during operation.
1. Clean and grease the bit shank.
2. Insert the bit shank into the tool holder/locking sleeve (D).
FIG. 2
3. Push the bit down and turn it slightly until it fits into the slots.
4. Pull on the bit to check if it is properly locked. The hammering
function requires the bit to be able to move axially several
centimetres when locked in the tool holder.
5. To remove a bit pull back the tool holder/locking sleeve (D) and
pull out the bit.
D
5
Fitting the Side Handle (fig. 3)
WARNING: Do not use the tool without the side handle properly
assembled.
The side handle (A) can be fitted to suit both RH- and LH-users.
1. Loosen the side handle.
2. For RH-users: slide the side handle clamp over the collar
behind the tool holder, handle at the left.
For LH-users: slide the side handle clamp over the collar
behind the tool holder, handle at the right.
3. Rotate the side handle to the desired position and tighten the
handle.
FIG. 3

OPERATION

WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories.
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: Be aware of the location of pipework and wiring.
WARNING: Apply only a gentle pressure to the tool (approx.
5 kg). Excessive force does not speed up chiselling but decreases
tool performance and may shorten tool life.
A