Connecting your PC to your RT50X rear projection display will enable you to view your computer's screen image for an impressive presentation.
To connect to a PC or Macintosh computer, simply:
1. Turn off the power to your rear projection display and computer.
2. Use the supplied signal cable to connect your PC or Macintosh computer to the rear projection display.
3. Turn on the rear projection display and the computer.
4. If the rear projection display goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you've connected
to the rear projection display.
NOTE: The new Macintosh computer such as G3 will
have the 15 pin HD connector. The RT50X "Plug and
Play" data will be downloaded to the Macintosh.
Therefore, a Mac adapter will not be necessary.
E – 21
STATUS
POWER
Push to select the
front terminal.
F R
O N
T /
R E
A R
RGB signal cable (supplied)
It is recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer