Receiver Connection And Installation; Binding A Receiver - Spektrum DX3E User Manual

reCeIver ConneCTIon and
InsTallaTIon
Typical Electric Installation
7.2V Battery
Electronic
Speed Control
Receiver
DSM™:: 2.4Ghz
SR300
Servo
Typical Gas Installation
Receiver
DSM™:: 2.4Ghz
SR300
AUX
Rx
SURFACE USE ONLY THR
STR
©2009 Horizon Hobby, Inc. BAT/TEL
SPEKTRUM DX3E USER GUIDE

bIndIng a reCeIver

1. With the receiver off insert the bind plug into the BND
port on the receiver.
2. Power the receiver through any other port. The amber
LED will flash continuously, indicating the receiver is
in bind mode.
3. With the steering wheel, throttle trigger and Aux
channel (if applicable) in the desired preset failsafe
positions, press and hold the bind button and turn
on the transmitter. The red LED on the front of
the transmitter will flash within a couple seconds
indicating the transmitter is in bind mode. Once the
red LED begins flashing, release the bind button.
To Motor
4. Within 15 seconds, the LED on the receiver will go
solid indicating a successful bind has taken place.
5. Remove the bind plug and store it in a convenient
place.
Note: You must rebind when:
• D ifferent failsafe positions are desired, e.g. when
throttle or steering reversing has been changed.
• C hanging receiver types, e.g. changing from a DSM
receiver to a DSM2 or Marine receiver.
• The receiver is to be bound to a different transmitter.
Note: Some Spektrum receivers, like the SR3000, use a
bind button rather than a bind plug. The binding process
is the same with this receiver; however, instead of
Throttle Servo
inserting the plug before powering up the receiver, press
and hold the bind button while powering up the receiver
Steering Servo
to enter bind mode.
6V Battery
Bind Plug LED
Bind Plug
EN
LED
7